User guide

Soundcraft 328XD and Digidesign Pro Tools
17
1717
17
Make Sure MIDI Dynauto is enabled on the 328XD. Set the automation mode to READ/WRITE.
In Pro Tools, arm the new MIDI track to record, and verify MIDI data reception.
Once MIDI data has been verified, you are free to record a pass of automation. Grab a handful of faders,
and do a test pass while in BANK SELECT 1-16.
After the test-pass has been recorded, rewind Pro Tools and play the pass back to the 328XD.
Faders should move accordingly – if they do not, verify your settings and try again. If MIDI data is
registering on the Pro Tools level meter when faders are being recorded, check the MIDI cable returning
to the 328XD.
Editing the Automation Pass
Once your pass has been recorded, you may want to edit it within Pro Tools. If you have Pro Tools 5.0 or
later, editing takes place as follows. If you have Pro Tools 4.3 or earlier, please continue to read this
section, as the proceedure is similar for your version.
Go to the Edit window in Pro Tools, and locate the MIDI track containing the automation pass.
Select the way the data is to be displayed - pure Controller Changes is recommended.