Specifications

D-Command Guide96
Mono Switch
The Mono switch mixes the Left and Right signals of any of
the output modes (any surround channels are not affected) to
provide mono output, useful for checking phase and balance
relationships. The Mono switch lights to indicate that it is ac-
tive.
Mono Trim Mode
Mono output can be trimmed to adjust its reference level in
comparison to other outputs. Available trim values range from
–12dB to 0dB, in 0.5dB steps.
To trim mono output:
1 Press and hold the Mono switch until it flashes.
2 Turn Alt Output encoder knob to set the Mono trim value.
The monitor display shows “Trim” and the trim value in dB.
3 Press the flashing Mono switch to exit Trim mode.
Dim Switch
The Dim function applies an adjustable gain reduction to the
Control Room outputs. This function affects all three output
destinations. The Dim switch toggles the dim function on and
off, and lights to indicate that it is active.
Mute Switch
The Mute switch toggles the mute state for all Control Room
outputs. Mute operates globally on all three output destina-
tions. The Mute switch lights to indicate that it is active.
If the Mute switch on the XMON interface front panel is acti-
vated, the Mute switch on D-Command must be used to un-
mute the monitor system. (Outputs cannot be unmuted from
XMON front panel.)