Specifications

Getting Started with Mbox 214
Clock Source
Using the Hardware Setup dialog, you can select
the clock source for the system.
Internal Use this setting if you are recording an-
alog signals directly into Mbox 2 analog inputs
1–2 and/or are recording digital inputs into
Mbox 2 inputs 3–4 where the digital device is
synchronized to the Mbox 2 digital output.
S/PDIF Use this setting if you are recording
through the Mbox 2 S/PDIF inputs from an ex-
ternal digital device. This setting will synchro-
nize Pro Tools to that digital device.
To select the clock source:
1 Choose Setups > Hardware Setup.
2 Choose the clock source from the Clock
Source pop-up menu.
3 Click OK.
Configuring I/O Setup
Using the I/O Setup dialog, you can label
Pro Tools LE input, output, insert, and bus sig-
nal paths. The I/O Setup dialog provides a graph-
ical representation of the inputs, outputs, and
signal routing of the Mbox 2.
Pro Tools LE has default I/O Setup settings that
will get you started. Use the I/O Setup dialog
only if you want to rename the default I/O
paths.
To rename I/O paths in I/O Setup:
1 Choose Setups > I/O Setup.
2 Click the Input, Output, Insert, or Bus tab to
display the corresponding connections.
3 To change the name of a path or subpath,
double-click directly on the Path Name, type a
new name for the path, and press Return.
4 Click OK.
T
Your digital input device must be connected
and powered on for Pro Tools to synchro-
nize to it. If your input device is not powered
on, leave the Clock Source set to Internal.
I/O Setup dialog for Mbox 2, Output page
Refer to the Pro Tools Reference Guide (or
choose Help > Pro Tools Reference Guide)
for more information on renaming I/O
paths.
After configuring Pro Tools LE and your
system, you should save an image of your
system using Norton Ghost. Norton Ghost
lets you save and recall known good config-
urations of your system and settings, which
can help you recover if you encounter any
problems in the future.
For more information on Ghost, visit the Sy-
mantec Web site (www.symantec.com)