Specifications

Chapter 5: Additional Operational Information 57
chapter 5
Additional Operational Information
Front Panel
Generator/Parameter
Controls
This section details the parameters available
from the multi-function SET, UP, DOWN and
RUN/STOP, CLEAR switches. (Referred to as Set,
Up, Down and Run). For details on the multi-
function Generator/Parameter switches, see
“Front Panel Generator/Parameter Switches” on
page 35.
Parameters
SYNC I/O parameters are selected and edited us-
ing the four Generator/Parameter switches.
To select SYNC I/O front panel parameters:
1 Press Set.
2 Use the Up and Down switches to scroll
through available parameters, described below.
The 7-segment LEDs in the Generator/Parame-
ter Display abbreviate some parameter names
using numerals to represent letters (such as “5”
to represent “S” or “s”). The following table
identifies each of these abbreviations.
Front Panel Parameters
SYNC I/O LED display of abbreviated parameter names
LED Parameter
SE7 6En Set Generator Start Time
dI6 rEF Digital Reference
SPL FrEC Sample Freq (Rate)
PuLL r7E 1 Pull Up/Down 0.1%
PuLL r7E4 Pull Up 4.167%, Down 4.0%
bASE CLOC External Clock Out
VI7C InS VITC Insertion
rdr LInE (VITC) Reader Line
6En LInE (VITC) Generate Line
burn EnA Window Burn On/Off
FrEE LEn Freewheel Duration
L7C 6AIn LTC Output gain
SErVo Gn LTC Servo gain
PICH HLd Pitch Hold On/Off
bIPH PPF Bi-Phase Pulse-per-frame
bIPH SI6 Bi-Phase Signal Configuration
VIdEO SY Video Format (NTSC/PAL)
IdLE 7C Idle MTC On/Off
USD CPA7 USD Compatibility On/Off