Specifications

Chapter 4: Using SYNC I/O 55
To enable a window dub using the front panel
controls:
1 Press Set, and use the Down and Up switches
to display Burn Enabled (burn EnA).
2 Press Set. The LED Time Code Display will
switch to display the current On or Off setting
for Window Burn.
3 Use the Down and Up switches to switch be-
tween the parameter values.
4 Press Set.
Based on the selected positional reference, the
time code character generator burns time code
addresses onto any video signal passing through
SYNC I/O.
Window Burn Display Options
If you need to change the appearance of the
window dub—in terms of size, vertical position,
horizontal position, and color—you need to use
Pro Tools or SYNC I/O Setup software utility
(Windows only). These parameters cannot be
adjusted from the SYNC I/O front panel con-
trols.
To configure a window dub using SYNC I/O Setup
(Windows only):
1 In the Dub Window section of SYNC I/O
Setup, select Window Enabled.
2 Specify the appearance of the window dub
with the pop-up menus for Vertical Position,
Horizontal Position, and Color.
Default Window Burn settings are listed in
“Restoring Factory Settings” on page 64.