Setup guide

• Make sure all the audio tracks are selected (not the aux input track!), so that the following changes can be applied
t
o audio tracks only. The track names should be highlighted to indicate that they are selected, which should be the
case just after they have been created. Otherwise, press and hold the Shift key (PC or Mac) and click the name field
o
f the first and last tracks to select the whole track range.
• Select Bus 1 as the input source for all audio tracks
On PC, Shift + Alt + click one of the selected audio tracks’ input button. On Mac, Shift + Alt + click one of the
i
nput buttons. Select Bus 1.
• Increment the audio track outputs (the audio tracks must still be selected)
On PC, Shift + Ctrl + Alt + click the output button of the first audio track. On Mac, Shift + Alt + Command + click
the output button. Select the first output path.
• Monitor the inputs of all audio tracks
On PC, Alt + click an Input Monitor button. On Mac, Alt + click an Input Monitor button.
• At this point, you should see signal in the Pro Tools audio track meters
• On the front panel of the Alpha-Link, press the METERS button to select D/A, you should see the metering LEDs light
up as they are receiving the signal
• Signals output via the Alpha-Link’s AES/EBU or ADAT outputs must be checked through your audio monitoring system
Page 14