User guide

Pro Tools|HD User Guide54
9 Configure any specific controls for your audio
interface:
• “Configuring HD OMNI Controls” on
page 54.
• “Configuring HD I/O Controls” on
page 55.
• “Configuring HD MADI Controls” on
page 56.
• “Configuring 192 I/O and 192 Digital I/O
Controls” on page 57.
• “Configuring 96 I/O Controls” on page 58.
• “Configuring 96i I/O Controls” on
page 59.
10 For additional Pro Tools|HD interfaces,
choose the interface in the Peripherals list, and
repeat the above steps.
Configuring HD OMNI Controls
To configure HD OMNI in Pro Tools:
1 Choose Setup > Hardware.
2 From the Peripherals list, select the HD OMNI
audio interface.
3 Click the Monitor tab and configure the op-
tions. When working with HD OMNI, you
should always configure the Monitor page first.
4 Click the Analog Out tab and configure the op-
tions.
See your peripheral’s guide for configuration
details and restrictions. For example, the
Optical 1–8 channels (on the 192 I/O enclo-
sure) will not be available at session sample
rates of 88.2 kHz or higher, while the ports
on the 192 I/O Digital I/O card will still be
available.
For detailed information about configuring
HD OMNI, see the HD OMNI Guide.
HD OMNI Hardware Setup, Monitor page
HD OMNI Hardware Setup, Analog Out page