Specifications

Digidesign Plug-Ins Guide70
To edit the Contour Line:
1 To move a breakpoint, click directly on it and
drag it to the desired position. Moving a break-
point higher increases noise reduction at that
range. Moving a breakpoint lower decreases
noise reduction at that range.
2 To move multiple breakpoints, Command-
drag (Macintosh) or Control-drag (Windows) to
select the desired breakpoints. Click the appro-
priate Move Breakpoint button (below the Spec-
tral Graph) to move the selected breakpoints in
1 dB increments. Command-Shift-drag (Macin-
tosh) or Control-Shift-drag (Windows) to ex-
tend your selection.
3 To move the entire Contour Line, Command-
drag (Macintosh) or Control-drag (Windows) to
select the entire range. Click the appropriate
Move Breakpoint button (below the Spectral
Graph) to move the selected breakpoints in 1 dB
increments. The higher you move the Contour
Line above the noise signature, the more noise is
removed.
4 To create a new breakpoint, click on the Con-
tour Line.
5 To delete a breakpoint, Option-click (Macin-
tosh) or Alt-click (Windows) the breakpoint. As
long as you click and hold the mouse, you will
delete all breakpoints that the cursor passes
over.
Using BNR AudioSuite
BNR AudioSuite is identical to the real-time ver-
sion of BNR, with the addition of two features to
enhance the noise reduction process. These fea-
tures are:
Audition Allows you to listen specifically to the
noise portion being removed from the target
material. This makes it easier to fine-tune noise
reduction settings to maximize noise reduction
and minimize signal loss.
Post-processing Applies post-processing to the
audio file to help remove undesirable artifacts
that are a result of noise reduction.
Dragging a breakpoint
Moving selected breakpoints