Specifications

Digidesign Plug-Ins Guide104
Spread Globally adjusts the delay characteristics
of the early reflections, moving them closer to-
gether or farther apart. Use Spread to vary the
size and character of an early reflection preset.
Setting the Plate preset to a Spread value of 50%,
for example, will change the reverb from a large,
smooth plate to a small, tight plate.
Delay Master Determines the amount of time
that elapses between the original audio event
and the onset of early reflections.
Early Reflect On Toggles early reflections on or
off. When early reflections are off, the reverb
consists entirely of reverb tail.
Reverb Graphs
The reverb graphs display information about
the tonal spectrum and envelope contour of the
reverb. The Reverb EQ and Reverb Color graphs
provide graphic editing tools for shaping the
harmonic spectrum of the reverb.
Reverb EQ
You can use this 3-band equalizer to shape the
tonal spectrum of the reverb. The EQ is post-re-
verb and affects both the reverb tail and the
early reflections.
Frequency Sliders Sets the frequency boundaries
between the low, mid, and high band ranges of
the EQ.
The low frequency slider (60.0 Hz–22.5 kHz)
sets the frequency boundary between low and
mid cut/boost points in the EQ.
The high frequency slider (64.0 Hz–24.0 kHz)
sets the frequency boundary between the mid
and high cut/boost points in the EQ.
Band Breakpoints Control cut and boost values
for the low, mid, and high frequencies of the
EQ. To cut a frequency band, drag a breakpoint
downward. To boost, drag upward. The adjust-
able range is from –24.0 dB to 12.0 dB.
HF Cut Breakpoint Sets the frequency above
which a 6 dB/octave low pass filter attenuates
the processed signal. It removes both early re-
flections and reverb tails, affecting the overall
high frequency content of the reverb. Use the
HF Cut parameter to roll off high frequencies
and create more natural-sounding reverbera-
tion. The adjustable range is from 120.0 Hz to
24.0 kHz.
Reverb Color
You can use the Reverb Color graph to shape the
tonal spectrum of the reverb by controlling the
decay times of the different frequency bands.
Low and high crossover points define the cut
and boost points of three frequency ranges.
For best results, set crossover points at least two
octaves higher than the frequency you want to
boost or cut. For example, to boost a signal at
100 Hz, set the crossover to 400 Hz.
Reverb EQ graph
High Frequency Cut
Band Out/Boost
Low Frequency slider High Frequency slider