Specifications

D-Control Guide20

3 Using a 5/32-inch hex wrench, attach the crossbar to the

brackets with 1/4-inch-20 x 1/2-inch button head cap screws

(see Figure 9), using 6 screws on each side (3 in front and 3 in

back). Make sure to leave the screws loose enough so that the

legs can be moved side-to-side relative to the rear crossbar.

4 Locate the rear pan support rail, which is the larger of the

two rails provided with the stand.

5 Position the rear rail so that the edge with the V-shaped

notch points toward the left stand leg.

6 Lift the rear rail into place so that the rail rests on the rear

rail tabs of the stand legs (see Figure 12). The holes on the ends

of the rail should line up with the slots in the rear rail tabs on

each leg.

Figure 9. Attaching the crossbar

Figure 10. Side view of pan support rails

Rear pan

Front pan

support rail

Figure 11. V-shaped notch in rear pan support rail

Figure 12. Rear support rail in place on left stand leg

Notch indicating left side of rear pan support rail