User Manual
Table Of Contents
- Contents
- Welcome to Digi 002 and Digi 002 Rack
- Windows Configuration
- Installation Overview
- Testing Digi 002
- Windows System Settings
- Connecting Digi 002 or Digi 002 Rack to the Computer
- Connecting FireWire Drives
- Installing Pro Tools LE
- Optional Software on the Pro Tools Installer CD-ROM
- Launching Pro Tools LE
- Configuring Pro Tools LE
- Hard Drive Configuration and Maintenance
- Removing Pro Tools on Windows XP
- Macintosh Configuration
- Installation Overview
- Testing Digi 002
- Apple System Settings for Mac OS X
- Installing Pro Tools LE
- Optional Software on the Pro Tools Installer CD-ROM
- Connecting Digi 002 or Digi 002 Rack to the Computer
- Connecting FireWire Drives
- Launching Pro Tools LE
- Configuring Pro Tools LE
- Hard Drive Configuration and Maintenance
- Removing Pro Tools on Mac OS X
- Digi 002 Top Panel
- The Digi 002 Rack Front Panel
- Digi 002 and Digi 002 Rack Back Panels
- Connecting Your Studio
- Working with Pro Tools LE
- Using Digi 002 as a Stand-Alone Mixer
- Windows System Optimizations (Windows Only
- Digidesign ASIO Driver (Windows Only)
- Digidesign WaveDriver (Windows Only)
- Digidesign CoreAudio Driver (Macintosh Only)
- Configuring Midi Studio Setup (Windows Only)
- Configuring AMS (Mac OS X Only)
- Digi 002 Stand-Alone Block Diagram
- Index
Communications & Safety Regulation Information
Compliance Statement
The model Digi 002 complies with the following standards
regulating interference and EMC:
• FCC Part 15 Class B
• EN55022
• EN55024
• AS/NZS 3548 Class B
• CISPR 22 Class B
Radio and Television Interference
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
DECLARATION OF CONFORMITY
We Digidesign,
3401-A Hillview Avenue
Palo Alto, California 94304-1348, USA
650-842-7900
declare under our sole responsibility that the product
Digi 002
complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following
measures:
• Reorient or locate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Any modifications to the unit, unless expressly approved by
Digidesign, could void the user's authority to operate the
equipment.
Canadian Compliance Statement:
This Class B digital apparatus complies with Canadian ICES-
003
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada
Australian Compliance
European Compliance