User Guide

Chapter 7: Using Digi 002 as a Stand-Alone Mixer 89
Channel Strip Controls
In Console View, each of the 8 channel strips on
Digi 002 controls its corresponding input.
Channel Name
The name of each channel appears in the Chan-
nel Scribble strips If you move a fader or rotary
encoder, the scribble strip temporarily shows
the volume level or pan position. You can re-
name each of the input channels. (See “Naming
Channels” on page 90.)
Encoder/Meter LED Ring
Encoder Mode In normal mode (when the “L”
and “R” Encoder/Meter indicators are lit), the
LED rings above the rotary encoders indicate
one of the following:
◆ In Pan View (or Home View), the LED rings in-
dicate channel pan position.
◆ In Send View, the LED rings indicate the level
for the selected send (A–D) for each channel.
◆ In Master Fader View, the Delay Return LED
ring shows pan position. (No other Rotary En-
coders are active in this view.)
◆ In Channel View, the LED rings display EQ,
Compressor, or Pan/Send information.
Meter Mode When you press the Encoder/Meter
mode switch to the right of the Channel View
area so the Meter LED is lit, the LED rings act as
meters in the following ways:
◆ In Pan View and Send View, the LED rings act
as post-fader meters for each input channel.
◆ In Master Fader View, the LED rings act as
post-fader meters for the effect return and Mas-
ter Fader channels.
◆ When viewing EQ controls in the Channel
View area, the LED rings act as post-fader meters
for each input channel.
◆ When viewing compressor controls in the
Channel View area, the LED rings act as input,
output, and gain reduction meters for the dis-
played compressor.
Digi 002 channel strip controls in Stand-alone Mode
SEL
MUTE
SOLO
+6
0
-10
-15
-20
-30
-90
-40
-60
-5
+3
Channel Name
Encoder/Meter LED ring
Rotary Encoder
Channel Solo and
Channel Volume Fader
Mute switches
Channel Select switch