User Guide

Getting Started with Digi 00246
Digi 002 includes preamps for these sources on
Inputs 1–4, with adjustable gain and available
48-volt phantom power. These inputs have both
XLR and 1/4-inch connectors; the XLR inputs
are specifically for connecting microphones,
and the 1/4-inch inputs are for connecting in-
strument outputs.
Line-Level Signals
Keyboards, preamps, and mixers output line-
level audio, which varies with each device be-
tween the –10 dBV and +4 dBu standards.
You can connect line level devices to any of
Digi 002’s Inputs 1–8, as follows:
Inputs 1–4 Inputs 1–4 have both XLR and 1/4-
inch TRS connectors. The XLR connectors are
for connecting microphones only. The 1/4-inch
TRS connectors are for connecting line-level de-
vices or instruments. Since these inputs have ad-
justable gain, they are especially useful for de-
vices that output low-level signals.
Inputs 5–8 These inputs accept 1/4-inch bal-
anced or unbalanced connections, and can be
switched between –10 dBV and +4 dBu opera-
tion.
To connect an analog audio source to Digi 002, do
the following for your type of input:
Microphones Plug a microphone directly into
any of the available XLR Microphone Inputs 1–4
on the back panel of the Digi 002.
■ Press the Mic/Line/Instrument Selector switch
(located on the top panel of Digi 002) for the
corresponding input so that it is in the “Mic”
position.
■ If your microphone requires phantom power,
press the Phantom Power switch (labeled 48V)
for the corresponding input pair.
Mic/Line Inputs 1–4 (back panel)
The XLR connectors on Inputs 1–4 are
wired specifically to match the impedance
of microphones. Do not use these XLR con-
nectors for line inputs; use the 1/4-inch con-
nectors instead.
MIC MIC
LINE/ INST LINE/ INST LINE/ INST LINE/ INST
1 23
4
MIC MIC
48V
48V
1/4-inch connectors
Phantom Power
switches
XLR connectors
Line Inputs 5–8 (back panel)
Mic/Line/Instrument Selector switches (top panel)
Although phantom power can be used
safely with most microphones, ribbon mi-
crophones can be damaged by it. You
should always turn off phantom power and
wait at least 30 seconds before connecting
or disconnecting a ribbon microphone.
+4 -10 +4 -10 +4 -10 +4 -10
INPUT 5
INPUT 6
INPUT 7
INPUT 8
Operating Level switches
1 GAIN 2 GAIN 3 GAIN 4 GAIN
LINE/ INST
MIC
Mic/Line/Instrument Selector switches