User Guide

Chapter 2: Macintosh Configuration 13
2 In Pro Tools LE, choose Setups > Hardware
Setup.
3 Make sure the correct digital input option is
selected for your setup. When you select RCA
S/PDIF, the Optical ports are available for stan-
dard ADAT Optical (or “Lightpipe”) input.
When you select Optical S/PDIF, the RCA digital
input connector is inactive.
4 From the Clock Source pop-up menu, select
Internal if you are synchronizing the external
device to Digi 002. If you are synchronizing
Digi 002 to the external device, select ADAT,
RCA (S/PDIF) or Optical (S/PDIF), depending on
where you connected your digital device.
Configuring I/O Setup
The I/O Setup dialog lets you label and map
Pro Tools LE input, output, insert, and bus signal
paths. The I/O Setup dialog provides a graphical
representation of the inputs, outputs, and signal
routing of the Digi 002.
Pro Tools LE ships with default I/O Setup set-
tings that will get you started. You only need to
go to I/O Setup if you want to remap or rename
the default I/O paths.
To configure I/O routing in I/O Setup:
1 Choose Setups > I/O Setups in Pro Tools LE.
2 Map and name paths as desired.
3 Click OK to close the I/O Setups dialog.
Your digital input device must be connected
and powered on for Pro Tools to synchro-
nize to it. If your input device is not powered
on, leave the Clock Source set to Internal.
I/O Setup dialog for Digi 002, Input page
Refer to the Pro Tools Reference Guide for
more information on setting up I/O paths.