User Guide

Chapter 2: Macintosh Configuration 7
chapter 2
Macintosh Configuration
Installation of the Digi 002 on a Macintosh in-
cludes:
• Powering up the Digi 002 unit. (See “Setting
Up Digi 002” on page 7.)
• Configuring Apple System Software settings.
(See “Apple System Settings” on page 8.)
• Installing Pro Tools LE Software. (See “Install-
ing Pro Tools LE Software” on page 8.)
• Installing OMS Software. (See “Installing and
Configuring OMS” on page 9.)
• Restarting your computer.
• Connecting the Digi 002 unit to your com-
puter. (See “Connecting Digi 002 to the Com-
puter” on page 9.)
• Making audio and MIDI connections to the
Digi 002. (See Chapter 5, “Connecting Your
Studio” for details.)
Setting Up Digi 002
Before you install Pro Tools LE software or con-
nect Digi 002 to your computer for the first
time, you should power up the unit to be sure it
is working correctly.
To set up and test the Digi 002:
1 Plug the Digi 002 into a standard AC recepta-
cle, using the AC power cable included with the
unit.
Digi 002 is auto power-selecting (100V to 240V)
and will work automatically when plugged into
an AC power receptacle in any country.
2 Power on the Digi 002 unit by turning on the
power switch on the back panel. After a short
power-up sequence, the Channel Scribble Strips
on the unit show “Digi 002 Standby,” and the
Standalone switch flashes to indicate Standby
mode.
3 Press the Standalone switch in the upper right
of the top panel of Digi 002. The Channel Scrib-
ble Strips on the unit show “Enter Standalone
Mode?”
4 Press the Channel Select switch under “Yes” to
enter Stand-alone mode. The Channel Scribble
Strips on the unit will show the default names of
the channel inputs, “In1” through “In8.”
5 Press the Standalone switch a second time to
put Digi 002 back into Standby mode.