User guide

reason. Perhaps another application is currently using DAE, or no valid drive is available."
Why is the MicroLynx option not available in the setups>machine control dialog box for PostConform v2.0?
When authorizing PostConform 2.0, the application throws the following error "The authorization count on your master
disk has been corrupted. -104".
I can't get PostConform to control the deck via machine control.
What are the synchronization equipment requirements for PostConform v2.0?
How do I recreate sources without starting a new session and importing the EDL all over again?
How does the sorting method I choose affect the order in which PostConform loads sources from the source tape?
-Why is PostConform locating the machine control deck in a random fashion while loading sources? -Why is
PostConform trying to load source items randomly or out of order from the reel/tape? -Why is PostConform prompting me
to insert the next reel/tape even though it has not finished loading all sources off of the current reel/tape? -Why is
PostConform prompting me to insert a tape it has loaded previously?
Why is PostConform 2.0 naming the sources in my source bin with strange names that make no sense such as the
following: 15A-01abYBx2kR4fr6h0.
[4295]
When I launch PostConform v2.0 I get the following message: "DAE could not be successfully acquired,
for some reason. Perhaps another application is currently using DAE, or no valid drive is available."
Pro Tools is most likely running concurrently with PostConform and is taking over the DAE application for its own
use. PostConform 2.0 is not qualified to run concurrently with Pro Tools 4.32 or below. DAE 5.0P allows Pro Tools
and PostConform to run simultaneously. The PostConform 2.0 installer doesn't replace 5.0 with 5.0P.
If you are using PostConform with Pro Tools 5.0, quit both Pro Tools and PostConform and replace the DAE
application (v5.0) on your system hard drive with the DAE application (v5.0P) from the PostConform 2.0 Installer
CD located in the DAE Folder. Launch Pro Tools and disable the Active In Background option under the Operations
menu. Launch PostConform and continue working. If you are using PostConform and Pro Tools 5.0.1 disable the
Active in Background option under the Operations menu in Pro Tools and continue working.
PostConform Index | All FAQ Index
[4296]
Why is the MicroLynx option not available in the setups>machine control dialog box for PostConform
v2.0?
Direct MicroLynx machine control support is not available in PostConform v2.0. The only machine control standards
that PostConform 2.0 supports are Sony 9-Pin (P-2), V-LAN, and VPR-3.
PostConform Index | All FAQ Index
[4298]
When authorizing PostConform 2.0, the application throws the following error "The authorization count
on your master disk has been corrupted. -104".
The only authorization key diskette that works with PostConform v2.0 is the "Authorizer for PostConform v2.0 for
Macintosh" diskette. If you have not received this diskette please call digidesign customer service during normal
business hours.
PostConform Index | All FAQ Index