User guide

6. The next window shows MIDI devices that are connected to your MIDI interface(s). Make sure there is an X in
the box next to the keyboard/question mark symbol which represents the port that you Motor Mix is attached to.
6. Name your Studio Setup.
7. Double-click the keyboard/question mark icon in the Session Setup window which is shown connected to the port
that your Motor Mix is attached to. The Manufacturer should be set to CM Automation, and the Model should be
designated as Motor Mix. You will see other options change when this assignment is made.
8. In Pro Tools, make sure Motor Mix is selected as an input device under the MIDI menu > Input Devices.
Motor Mix Index | All FAQ Index
[3975]
When I try to locate to a memory location using Motor Mix in Transport Mode, Pro Tools does not
respond. Other communication functions seem normal.
Make sure Pro Tools is using its "classic" keypad configuration in Preferences > Operation. If it is already set to
"classic", try quitting Pro Tools, trashing the Pro Tools preferences (Mac HD > System Folder > Preferences), and
restarting the computer. You may need to make adjustments to some preferences and peripheral settings after
doing this.
Motor Mix Index | All FAQ Index
[3977]
How is "Fader Punch Mode" on the Motor Mix different than standard Pro Tools mode? It seems that I
can perform the same automation functions in either.
There is no difference. Earlier in the development of Motor Mix it was necessary to enter Fader Punch Mode in order
to punch in automation, but this is no longer the case.
Motor Mix Index | All FAQ Index
[3979]
How can I get the latest Motor Mix firmware?
Contact CM Automation through the support site of their website:
www.cmlabs.net
[e-mail]
http://www.cmautomation.com
Motor Mix Index | All FAQ Index
[4187]
How do I set up OMS to use Motor Mix if I AM using a Mark of the Unicorn (MOTU) USB MIDI interface?
1. OMS should be installed first, and the computer restarted.
2. Install FreeMIDI (version 1.4 or greater) and restart the computer once again.
3. Launch FreeMIDI setup, and when asked to choose between FreeMIDI and OMS choose OMS. This will assure
that FreeMIDI is operating in OMS compatibility mode.
3. Launch OMS Setup, or choose OMS Studio Setup from the Setups menu in Pro Tools. Click OK when the first
window appears.
4. In the next window, leave the modem and printer boxes unchecked and click OK.
5. The next window should list your MIDI interface(s). Click OK.
6. The next window shows MIDI devices that are connected to your MIDI interface(s). Make sure there is an X in
the box next to the keyboard/question mark symbol which represents the port that you Motor Mix is attached to.
6. Name your Studio Setup.
7. Double-click the keyboard/question mark icon in the Session Setup window which is shown connected to the port