User guide

Is the 192 Digital Audio Interface expandable like the 192 Audio Interface (with optional Digital I/O, D/
A or A/D converter cards)?
No. The 192 Digital I/O uses a different power supply that is incompatible with the 192 analog cards.
192 I/O Index | All FAQ Index
[7871]
Can I use the Digidesign 192 interface to perform analog transfers directly from industry standard multi-
track recorders? Have you tested for frequency response anomalies on a transfer like this?
Yes you can, and yes we have.
Visit this location for the full details:
http://www.digidesign.com/support/faq/192/
192 I/O Index
| All FAQ Index
[7448]
How do you set the 192 I/O's enclosure optical port to ADAT optical. There is no selection for this in the
hardware setup.
The enclosure optical port defaults to ADAT optical and will function in ADAT mode unless S/PDIF Optical is selected
in the hardware setup.
192 I/O Index | All FAQ Index
[7450]
How many legacy peripheral can I connect to the legacy port on the 192 I/O
Two 8 channel interfaces or One 16 channel interface.
192 I/O Index | All FAQ Index
[7451]
The user guide talks about calibrating the 192 I/O but there are no specific instructions. Where can I
get them.
The calibration guide is available at our web site. http://www.digidesign.com/support/
docs/192_IO_Calibration_Mode.pdf
192 I/O Index | All FAQ Index
[7453]
How can I stream audio digitally from my old 44.1/48k effects processors into higher sample rate
sessions
The 192 I/O comes with one 192 Digital card installed with the option to install a second card. The inputs and
outputs on both cards can be configured for realtime sample rate conversion on a per input basis. This allows you to
use older effects units digitally or to stream audio into higher sample rate session from sources like ADAT or DA-88.
192 I/O Index | All FAQ Index
[7454]
In the past Digi interfaces always mirrored the output of the analog out at the digital out. The 192 does
not do this is there a way to emulate the old behavior.
Yes, the 192 I/O lets you assign multiple outputs by Control Clicking on the Output selection on the main tab of the
hardware setup. You can choose the enclosure analog outputs and combine them with any of the enclosure digital
outputs.
192 I/O Index | All FAQ Index
[7452]
If I want to make my own cables for the 192 I/O which pin is hot?
Pin 2 is hot.
192 I/O Index | All FAQ Index