User guide

Physical Connections
---------------------
- Connect out the ADAT sync (sony 9-pin) in to the JLCooper dataSYNC2.
- Complete the loop by connecting out the JLCooper back into the ADAT sync.
- Connect optically out of the ADAT in to the Digi 001 optical in (on the card in the computer) note: optical out has
a red light emanating from it.
- Connect MIDI out of the JLCooper to the Digi 001 MIDI in.
- Complete the loop with MIDI out the Digi 001 back into the JLCooper dataSYNC2.
JLCooper dataSYNC2
---------------------
- Turn on the JLCooper after you've powered up the ADAT (ADAT clock set to internal)
- Set the desired frame rate on the dataSYNC2 to match the ADAT and Pro Tools frame rate.
- Enable MTC on the dataSYNC2 by pressing the "MTC On" button.
OMS Studio Setup
---------------------
- Double click on the keyboard with a "?" (branching off of the 001)