User guide

[4438]
Why is the Speed Cal Light Blinking?
Verify the clock reference in the session setup e.g., if you're feeding the USD Black Burst, clock reference should =
Vid Ref. If it is set to the wrong reference e.g., LTC, the USD cannot resolve.
Here are some important Session Setup settings to verify when trouble-shooting sync:
Clock Reference
Positional Reference
Sync Mode
Frame Rate
Sample Rate
USD Index | All FAQ Index
[4439]
Can I use the 9-pin port on the back of the USD?
No. Currently, the 9-pin port is not supported.
USD Index | All FAQ Index
Windows 98 SE and ME Setup
Can I run my soundblaster card in the same hardware profile with my Digi 001 or Audiomedia III system on Win98 SE or
WinME?
How to Check your system for any resource (IRQ) conflicts on Win98 SE and WinME.
How do I Enable DMA for all IDE/ATA drives in on Win98 SE and WinME?
Disable all Startup Items from the system to prevent conflicts when using Pro Tools LE software on Win98 SE and
WinME
In general is there anything I should know about driver errors?
How to set the Multimedia control panel settings for use with Pro Tools LE for Win98 SE and WinME.
How to change the "Role" of the computer.
How to lower the Color bit depth in Display settings for use with Pro Tools LE for Win98 SE and WinME.
How to setup power schemes and screensavers for use with Pro Tools LE for Win98 SE and WinME.
How do Reduce Video Hardware Acceleration to improve system performance on Win98 SE and WinME?
How do I improve disk performance with Pro Tools LE for Win98 SE and WinME?
[8199]
Can I run my soundblaster card in the same hardware profile with my Digi 001 or Audiomedia III
system on Win98 SE or WinME?
It is known that many Sound blaster cards will share the parallel port IRQ without any indication in Windows.