Setup guide

003 Family Setup Guide122
3 Do one of the following:
• To confirm and save the preset, select OK
by pressing the Master Bypass switch.
– or –
• To cancel without saving the preset, select
Cancel by pressing the ESC switch.
Factory Default
003 lets you reset any preset to its factory default
setting (see “Factory Presets” on page 122).
To reset a MIDI Map preset to its factory default
setting:
1 Enter MIDI mode.
2 Press the MIDI Recall switch. The MIDI Recall
switch LED flashes.
3 Select the MIDI Map preset you want to reset.
4 Select Recall by pressing the Page Right switch.
5 Select Default by pressing the flashing Insert
switch. The Insert switch lights solid.
6 Do one of the following:
• Select OK by pressing the Master Bypass
switch. The selected MIDI Map preset is
overwritten by its default preset.
– or –
• To cancel without overwriting flash mem-
ory and the selected preset with its factory
default preset, select Cancel by pressing the
ESC switch.
Factory Presets
003 comes with factory presets saved in flash
memory. Presets A1–4 and B1–4 provide factory
preset MIDI Maps for the following:
Standard MIDI Map Use this preset for standard
MIDI controller mappings (for example, with a
third-party application). See Table 13 on
page 123.
003 Map Use this preset to control a ReWire cli-
ent (such as Reason). See Table 14 on page 129.
Strike Map Use this preset to control Digi-
design’s Strike plug-in. See Table 15 on
page 135.
Uninitialized Preset Use this preset as a starting
point for your own custom mappings. All map-
pable 003 controls are unassigned.
Recalling the default preset overwrites the
preset stored in flash memory. To be able to
recall the preset currently stored in flash
memory, you must save it to a different pre-
set than the one you for which you want to
recall the default. For example, if you want
to recall the default preset for A1, save the
currently loaded preset to A4 first.