Setup guide

003 Family Setup Guide102
Naming Tracks of Adding Track
Comments
To open the Track Name/Comments dialog (to
change a track’s name or comments):
 In Pan View, double-click the track’s Channel
Select switch.
To close the Track Name/Comments dialog:
 In the Channel View section, press the ESC
switch.
Navigating Track Name Field in the Track Name
Dialog
You can move the cursor when you are naming
tracks in the Track Name dialog.
To move the cursor while naming a track, do any of
the following:
 Press the Left or Right Arrow key to move the
cursor backward or forward through the name
field.
 Press the Up or Down Arrow key to move the
cursor to the beginning or end of the field.
 Hold Command/Ctrl and press the Up (or
Left) or Down (or Right) Arrow key to move to
the previous or next track name field.
Assigning Pro Tools Paths
(Input, Output, Sends,
Inserts)
Channel inputs, outputs, inserts, and sends can
be assigned directly from the 003 in Assign
mode.
Inputs and outputs are assigned in Pan View,
sends are assigned in Send View, and inserts are
assigned in Insert View.
Inputs and Outputs
To assign an input or output:
1 Press the Pan switch in the Console View sec-
tion.
2 On the channel where you want to make the
assignment, do one of the following:
• To assign the output of a track, press its
Channel Select switch for 2 seconds.
– or –
• To assign the input of a track, hold Shift
and press the track’s Channel Select switch
for 2 seconds.
The LCD changes to display the selected path
and the Channel Select switch flashes.
3 If you are assigning a different input or output
path type than the current type displayed on the
LCD (such as a bus instead of an interface), do
the following to select a new path type:
• Hold Command/Ctrl and press the Chan-
nel Select switch to display the name of the
current path type in the main menu. The
main menu includes a dash (“–”) for no as-
signment, intrfc (interface), bus, and
plug-in (inputs only).
• Use the rotary encoder to scroll through
the list of path types.
• Press the flashing Channel Select switch to
select the path type.
4 Use the rotary encoder to navigate through
the available input or output paths in the sub-
menu.