Setup Guide

003 Family Setup Guide98
The Channel Select switches on channels 3–7
toggle pre- and post-fader metering for the cor-
responding send.
To adjust send levels for any of the sends on a
single track:
1 Press the Pan/Send switch in the Channel
View switch section.
2 Press the Channel Select switch for the track
with sends you want to view.
3 Adjust a channel’s send level by turning its ro-
tary encoder.
To adjust pan levels on a track that has sends:
1 Press the Pan/Send switch in the Channel
View switch section.
2 Press the Channel Select switch for the track
with sends that has panning you want to adjust.
3 Do one of the following:
• If the track is a stereo track, toggle the
Meter switch to Left or Right.
– or –
• If the track is a mono track, toggle the
Meter switch to Left.
4 Adjust the track’s panning by turning the ro-
tary encoder in the first fader strip.
To toggle a send between pre- and post-fader
operation:
1 Press the Pan/Send switch to put 003 in Chan-
nel View.
2 Press a lit Channel Select switch to display the
sends for the corresponding track.
3 Press the Channel Select switch under a send
name to toggle its pre- and post-fader setting.
Display Options in Console
and Channel View
Displaying Full Names of Tracks, Insert
Parameters, and Other Elements
Track names and other parameters displayed on
the lower row of the LCD are abbreviated to six
characters. Full names can be temporarily dis-
played on the top row of the LCD.
To display full names of tracks and insert
parameters, do one of the following:
 In Pan View, hold Display and press the Chan-
nel Select switch for the track whose name you
want to see displayed fully. The name displays
on the left side of the top row of the LCD dis-
play.
– or –
 In Insert View, when editing plug-in parame-
ters, hold Display and press the Channel Select
switch for the parameter whose name you want
to see displayed fully. The name displays on the
far right side of the top row of the LCD display.
Displaying Settings Instead of Track or
Control Names
The lower row of the LCD shows track or control
names by default. The display can be changed to
temporarily show settings, or be reset to always
show settings. The Display Mode switch flashes
during a temporary display or when the LCD de-
fault has been reset to always show settings.