Operation Manual

49
Parameters Description
Enable QoS by Application Enable application-based QoS.
Protocol/Specific Port# Set the priority of the specified protocol
name or port number to higher or lower
priority.
Enable QoS by device port Enable Port-based QoS.
Click <Apply> at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)
2.5.2 Rate Policing QoS
This router supports Rate Policing QoS. User can specify a L3/4 criterion
and associate it with a maximum token (packet rate or data rate based). If
a packet arrives and it matches to a rate policing entry, router decreases
entry’s allocated token by on e (if p p s based) o r by packet length in b ytes(if
bps based). If unfortunately the packet just run out of allocated tokens,