User`s manual

MICHELANGELO SHDSL VPN Firewall Bridge/Router

Chapter 4:Configuration

SHDSL

4-wired Mode

2-wired Mode

4-Wired Connection: MICHELANGELO SHDSL supports either 2-wire and 4-wires SHDSL connection.

Activate the device to 4-wired by enabling the function; otherwise, disable it to be used as 2-wire mode

connection.

Note: When select 2-wired mode, only Port 1 settings need to be configured and the SHDSL (RJ-11 cable) must be

connected to LINE 1 on the back of the device.

Mode: The SHDSL device can function as a CPE (Customer Premises Equipment) or CO (Central Office).

Select CPE mode when the Michelangelo SHDSL is connecting to your ISP.

Back – to –back: it is a direct connection between two SHDSL devices which one is set to CPE and the other is

CO by using a standard RJ-11 telephone cable.

Annex Type: It is the DSL operating mode standard. Select Annex A or Annex B to support up to 2.3Mpbs (for

2-wired mode) and 4.6Mpbs (for 4-wired mode). Select other annex such as Annex B_ANFP / Annex

A_B_ANFP, you may consult with your ISP first.

Back – to –back: to be sure the Annex type is the same on the MICHELANGELO SHDSL and the remote

router.

Bit Rate Mode: The mode selections are Adaptive and Fixed. Selecting the Adaptive mode, the best

connection rate will be automatically negotiated with the CO / ISP. Selecting the Fixed mode, the connection

rate will be fixed to the specific fixed bit rate selected with the CO / ISP.

Fixed Bit Rate: Specify the fix transfer rate when Fixed Mode is selected. Specify the maximum transfer rate

when Adaptive Mode is selected. Bit Rate range is from 72kbps ~ 2368kbps.

Activate Line: Line active true is set by default. Select false to disable and true to enable SHDSL SHDSL

connection

Note: Once Active Line is selected as false, you must enable the Active Line to true again and click Apply button to

reactivate SHDSL connection.

DSP FirmwareVersion: Display the SHDSL line code firmware version.

Connected: Display current SHDSL line sync status.

State: Display current SHDSL line status.

Bit Rate: Display SHDSL line synch speed rate.

Click Apply button to apply your changes