User`s guide

3.2
3G Gateway Series WEB Conguration
3.1. QUICK CONFIGURATION
Thisparagraphdescribesthemainparameterstobesettomakeandreceivecalls(iftheFXS“TEL”interfaceissupported)and
to start the Internet surfing in 3G mode.
3.1.1. Phone Call
For FxS interface versions only.
To start making/receiving calls you must have followed the instructions of the Hardware Installation chapter:
• ConnecttheGSMantenna
• InserttheSIM(werecommendtodisablethePIN)
• ConnectaphonetotheconnectorTel1
• Connectthepowersupplyandturn3GGatewayon
• Assoonasthedisplay(or3Gled)willshowtheoperatorname,youwillbeabletomakeandreceivecalls.
3.1.2. 3G Data Call
Tomakeacallin3Gmode,checkthattheWANissetto3G(Congurationmenu,WAN,WANconguration).
• Inthe3G UMTSmenuinserttheinformation(dependingontheGSMoperatoryouareusing)forAPN,UsernameandPassword
(forsomeoperatorstheAPNissufcient).
• Denetheconnectionmode:
Always on: 3G Gateway will enable 3G connection at power on. If some disconnections should occur, the Gateway
will try to restore them automatically.
Manually: In this mode the user manually decides when the connection must be enabled and for how long. To enable
(connect)andddisable(disconnect)3Gconnection,usethepushbuttonsintheHomepage.
Note: Verify with your telecom operator the profile of the SIM you are using for the Internet connection.