User`s guide

Digi International, Inc. User’s Guide
- 19 -
Wi-Fi MAC Access Control List: The MAC addresses of stations which have been
allowed or denied to connect to the Digi Wi-Point 3G are saved in this list box.
To input the MAC address, use the MAC address edit box on the page (below the ACL),
the input MAC address format must be XX:XX:XX:XX:XX:XX.
DHCP Server Settings
This setting is used to configure the Digi Wi-Point 3G’s Dynamic Host Configuration
Protocol (DHCP) server function. The Digi Wi-Point 3G can be used as a DHCP server for
the internal Ethernet network. The DHCP server automatically assigns an IP address to
each computer in the Ethernet network. If you choose to enable the Digi Wi-Point 3G’s
DHCP server option, you must configure all of PCs in the Ethernet network to connect to
this DHCP server (Digi Wi-Point 3G), and make sure there is no other DHCP server on
your network.
DHCP is enabled by factory default. If there is already a DHCP server in the Ethernet
network or a DHCP server is not necessary for the Ethernet network, the Enable DHCP
Server on LAN Interface box can be un-checked. (Other DHCP features will be disabled).
• IP Addresses: Enter the values for start IP address and end IP address.
The default start IP address is 192.168.1.2 and the default end IP address
is 192.168.1.100.