User`s guide

Digi International, Inc. User’s Guide
- 16 -
192.168.1.1
• Subnet Mask: The subnet mask of the Ethernet & WLAN. The default subnet
mask is 255.255.255.0.
Once you have configured these parameters, click Apply.
Wi-Fi LAN Settings
• Network name (SSID): The name used to identify a particular network. The SSID
must be identical for all the access points in the wireless network.
• Enable Broadcast SSID: When wireless clients survey the local area for wireless
networks, the SSID broadcast is detected by the router. The Enable Broadcast
SSID is checked by default. If you do not want to broadcast Digi Wi-Point 3G's
SSID, clear the box.
• Wireless Channel: Select the appropriate channel from the list provided to
correspond with your network settings. All client devices in your wireless network
must be broadcast on the same channel in order to function correctly.
• Network Mode: From this drop-down menu, select the wireless standards running
on your network. If you have both Wireless-g and Wireless-b devices in your
network, keep the default setting as Mixed.
• Enable stations isolation: If you don’t want different client stations connected to
the device to communicate with each other, check Enable.
Max associations: The maximum client stations allowed to be connected to the Digi
Wi-Point 3G. Once you have configured these parameters, click Apply.
Wi-Fi Security Settings: This configuration page is used to set wireless Ethernet security
parameters. The Digi Wi-Point 3G supports three different types of security settings for
your wireless Ethernet network: Wi-Fi Protected Access (WPA), Pre-Shared Key (PSK),
WPA2-PSK, and Wire Equivalence Protection (WEP).