Installation guide
Digi TransPort
®
WR11 Installation Guide
Page 11
Digi TransPort WR11 Provisioning
CDMA provisioning is different from GSM since CDMA (in most cases) does not use a SIM card. The CDMA
module provisioning process creates a CDMA data connection to the mobile carrier network. This authenticates
the modem and retrieves account information which is written to ash memory on the CDMA module itself, not
the Digi’s conguration le. Mobile account information is stored on the CDMA module. Therefore, you cannot
remove provisioning information from the CDMA module by performing a factory reset on the TransPort WR11
device.
If provisioning fails (the device does not obtain a phone number), contact the carrier and verify that the device
has an active account. You will need to provide the MEID of the device which is available under Management
- Network Status > Interfaces > Mobile.
The status of a successfully provisioned CDMA module is shown in the following image. Note that the device
has obtained a phone number.