User manual

4REA4 Controller Software User Guide

V1.30

Channel Count – when connecting to an SD console, channels must be ‘reserved’ on the Optocore

loop. Choose the number of channels needed from the drop down menus.

NOTE: Input Channel Count refers to the inputs from the 4REA4 to the Optocore loop (outputs from the

4REA4) and vice versa for the Output Channel Count

15.6 DMI Dante

DMI Dante card will need Dante Network configuration in addition to its Sync Source settings.

All DANTE devices should be configured using Dante Controller which is available from:

https://www.audinate.com/products/software/dante-controller

15.7 DMI Dante 64@96

DMI Dante 64@96 allows 64 channels at 96kHz. It behaves and is controlled in the same way as the original

DMI Dante, with the addition of SRC. SRC is supported down to a Dante network running at 48Khz and is

enabled by clicking the “Disabled” button beneath “SRC Engine/Dante”.