User manual

4REA4 Controller Software User Guide

V1.30

9.12 Talkback

Use this screen to assign and configure Talkback.

Assign – Click a Mix button to assign Talkback.

Settings – Use this page to choose the Talkback source and set its options.

General – The default Talk switch operation is momentary (press and hold while talking). Turn on

Enable Latching for latching operation (press to turn on, press again to turn off).

Enable Dim Solo on Talkback attenuates the soloed signal while talking to prevent feedback from the

engineer’s monitor into the Talkback microphone.

Source Select – Use the drop-down menu and Socket box to select the Talkback source from any

system input. Press Apply to confirm.

Talkback Source Input Setup – Set the source Gain, Trim, Pad and phantom power. You can also

make the source Safe from snapshot recall.

HPF – High Pass Filter frequency and In/Out switch.