User manual

4REA4 Controller Software User Guide

V1.30

2.11 EQ

The Parametric Equaliser provides 4 fully adjustable bands of equalisation. It can be adjusted using the

mouse on the graph by clicking and dragging the parameter values.

⚙ Click Setup and then click the navigation tabs area to access channel options including the processing

order of EQ and Compressor. The default order is EQ first, Compressor next. You can invert the order on a

per channel basis or globally.

 The EQ/Comp order for each channel is stored in Session files. It is not stored in snapshots.

⚙ Click Setup and then click anywhere in the EQ screen to access the Global channel EQ options the

frequency range for the 4 bands may be set globally for all Input or Mixes to be limited or Full Range.

Graph – Click and drag the 4 band dots to adjust their centre frequencies. Click and drag the HPF /

LPF dots to adjust their cut-off frequencies. The overall frequency response curve is highlighted when the

EQ is switched in and dim when switched out.

EQ Settings – Frequency sweeps the shelving, centre or cut-off frequency for each band. Width

adjusts the width in octaves of the bell shaped EQ band. Gain allows up to +/-15dB boost or cut for each

band. The LF and HF EQ bands can be set as shelving, bell shaped or low/high cut 12dB/octave filters.