User manual

4REA4 Controller Software User Guide
12
V1.30
The following displays are available in this version of software:
Gate and
Comp
Gate with signal
meter, graph,
gain reduction
meter,
Threshold and
Depth control;
Compressor
with signal
meter (pre and
post), graph,
gain reduction
meter, Ratio,
Threshold and
Gain control.
Gate
Signal meter,
graph, gain
reduction
meter,
sidechain
graph,
histogram,
Threshold,
Depth, Hold,
Attack and
Release
control.
Comp
Signal meter,
(pre and
post), graph,
gain
reduction
meter,
sidechain
graph,
histogram,
Ratio,
Threshold,
Gain, Attack
and Release
control.
Snapshots
Scrollable
snapshot list.
Click a
snapshot to
select.
The selected
snapshot is
highlighted in
blue.
The Next
Snapshot is
highlighted in
green.
2.3 Copy/Paste/Reset, Setup, Solo and Preset buttons
The functionality of these buttons is as follows:
Copy – Click the Copy button and then click any highlighted area of the screen to copy the settings of a
specific processing block. A temporary message will appear at the bottom of the screen to confirm the
operation.
Paste - Click the Paste button and then click any highlighted area of the screen to paste copied settings. A
temporary message will appear at the bottom of the screen to confirm the operation.
Reset - Click the Reset button and then click any highlighted area of the screen to reset the associated
parameters to factory default. A temporary message will appear at the bottom of the screen to confirm the
operation.
⚙ Setup – Click the Setup button and then click any highlighted area of the screen to configure it. For
example, click a display area to set up functions, views or controls. Switching from one display mode to
another eg Processing to Bussing will display further setup options.
Solo – Click the Solo button and then click any highlighted area of the screen to solo the selected channel at
that point in the signal path. The signal temporarily overwrites the Solo bus and associated meters. Press
the Solo Clear button to cancel.