User's Manual
Bluetooth Software Suite User’s Manual
64
Diagnostics
After the installation, it is recommendable to check
that the hardware for the Bluetooth Software Suite
(i.e. either a PC card or a USB adapter) has been
installed properly. This is done by performing a
loopback test. The test is carried out from the
Bluetooth Configuration Tool:
1. Open the Microsoft Control panel.
2. Double-click Bluetooth Configuration Tool.
The Bluetooth Configuration Tool dialog box
opens:
3. Click the tab Diagnostics. The following
window opens:
You can now perform a loopback test to
check that the hardware is working properly:
4. In Loop Mode, select either Single Loop (to
test a single loop) or Infinite Loops (to test a
number of loops). We recommend that you
choose the latter (which is also the default
setting).
5. To start the test, click Run. When in the loop
mode Infinite Loops, the test will run until you
click Stop.
6. In Loop Count you can see the number of
loops tested. The number of Errors should
always be: 0. If the test shows one or more
errors, your hardware has probably not been
installed correctly. We recommend that you: