User's Manual
Table Of Contents
- Introduction
- Attaching the Module to Your Phone
- Introducing Devices to Each Other
- Linking with a PC or Data Device
- Linking with a Bluetooth Headset
- Ending a Bluetooth Connection
- Customization Features
- Troubleshooting
- Glossary
- Limited Warranty for Motorola Personal Communications Products and Accessories Purchased in the U...
12
Introducing Devices to Each Other
Introducing Your Phone to a PC
Your Bluetooth-enabled PC must
discover
your phone before they can
connect. The first time that these two devices connect, they
bond
.
Bonding
is a process through which the phone and PC exchange identifying
information. For future connections, these same devices can bypass this process
(because they already recognize each other) and connect immediately. (See the
instructions in “Linking with a PC or Data Device” on page 18.)
Note: Whenever one of the following steps directs you to perform a function on your
PC, refer to the PC accessory card software user’s guide for instructions.
To set up your phone for connection to a PC:
Action Result
1
Make sure you have installed
the Bluetooth PC card in the PC
and loaded the Bluetooth PC
software.
(
See the PC accessory
card installation and software
user’s guides for instructions.)