User's Manual

MOTOROLA Setup 3-9
Preliminary
Chapter 3
Setup
This section explains how to set up the 72000 Development Kit hardware and software. Do the following:
1. Attach external antenna to the 50 ohm connector on the development board.
2. Attach the development board to your computer using the UART (RS232) cable.
3. Attach power supply to DC connector on board and connect to main electricity supply.
4. Insert the CD in the CD-ROM drive of your computer and follow the onscreen instructions
to install the software and documentation.
5. Launch the Configuration Manager and make sure it is the only Development Kit
application running.
6. Select the "72000 - UART Application - Audio through Codec" configuration in the
Configuration Manager and click the Make Active button.
You can now use UART or RS232, however not simultaneously.
NOTE:
The first time the Configuration Manager is attached to a board, it will
advise you to make a backup of the configuration on the board. A backup
is necessary to save the board’s original settings. The backup will be called
Factory Settings for device XXXXXXXXXXXX.