User's Manual

MOTOROLA Setup 3-9
Motorola Confidential Proprietary, NDA Required / Preliminary
Chapter 3
Setup
This section provides instructions for setting up the Development Kit hardware and software.
3.1 Setting Up Board
To get the board up and running, do the following:
1. Connect the board and PC via the UART (RS232) cable.
NOTE:
The first time you start up the board, you can only run UART, not USB.
2. Attach power supply to DC connector on board and connect to main electricity supply.
3. Insert the CD in the CD-ROM drive of your PC and follow the onscreen instructions.
3.2 Running UART
To run UART, do the following:
1. Get the board up and running as described above.
2. Download the UART application from the Configuration Manager on the CD.
3.3 Running USB
NOTE:
The first time you start up the board, you can only run UART, not USB.
Follow the above setup instructions.
To run USB, do the following:
1. Make sure the power is turned off the board.
2. Connect the board and PC via the UART (RS232) cable.
3. Attach power supply to DC connector on board and connect to main electricity supply.
4. Download the USB application from the Configuration Manager on the CD.