Quick Start Guide

Demonstration Applications
Zigbee/802.15.4 Evaluation Kit, Rev. 0.0
Freescale Semiconductor 9
8. If led D104 is blinking repeatedly then the board is in Transmit mode. If led D104 is not blinking,
then set switch S106 again. If the LED is still not blinking, repeat the previous step.
9. Verify that both boards are communicating correctly by checking the receiver board to verify if
led D103 is blinking repeatedly. If led D103 is not blinking, then press switch S106 turn. If the
boards are still unable to communicate, replace the batteries and perform Step 2 and Step 3 again.
Refer to the Accelerometer Quick Start Guide Application Note, AN2762 for more details.