Quick Start Guide

Zigbee/802.15.4 Evaluation Kit, Rev. 0.0
8 Freescale Semiconductor
Demonstration Applications
6.2 DIG-536-2 Demonstration Applications
The demonstrating applications that run on the DIG-536-2 PCB use version 1.00 of the Simple Media
Access Controller (SMAC). Refer to the SMAC Reference Manual, SMCRM/D for more details. The
SMAC is a smaller and less complex implementation of the 802.15.04 MAC/PHY layer. There is no
network layer in this application. All applications use the Freescale Embedded Bootloader for simplified
firmware updates.
Figure 5. DIG-528-2 Accelerometer Application Layers
6.2.1 Accelerometer Demonstration Application
The Accelerometer demonstration application requires two DIG-536-2 boards with the Accelerometer
Demonstration application already loaded. Perform the following steps.
1. Insert the MC13192 Resource CD into your CD-ROM drive. If auto install is disabled on your
personal computer (PC), run the home.htm file from the root on the CD.
2. Select the serial connection and power-up the receiver SARD board.
3. Connect the first SARD board, which will be the receiver, to the PC serial port using a DB9
male/female serial cable included in the development kit. Verify that no jumpers are installed on
this board.
4. Connect a 9V battery or a 5.5-9V power supply to the power supply connector and set switch
S105 to the “ON” position. This board is now in receive mode.
5. The second board, which will be the transmitter, must have three jumpers installed to ensure
proper operation. Verify that jumpers are placed on pins 1 & 2 (PTB0), pins 3 & 4 (PTB1), and
pins 11 & 12 (PTB7).
6. Connect a 9V battery or a 5.5-9V supply to the power supply connector and power on the board
by setting switch S105 to the “ON” position.
7. Hold any one of the switches (S101, S102, S103, or S104) down while at the same time holding
down switch S106. First release S106, then release the other switch.
Accelerometer
Application
Non Volatile Memory
802.15.4 SPHY
Device
Driver
GPIO
Embedded Bootloader
802.15.4 SMAC
MC908HCS08GB60/-GT60/MC13192
S101
I/O
S102
S103 S104
User Interface Push buttons