Product manual

ManualsBrandsDigi ManualsPrint & ScanXStream-PKG-R RS-485

XStream-PKG-R™ RS-232/485 RF Modem – Product Manual v5.x00

DR (DI3 Configuration) Command

<Serial Interfacing> The DR Command is used to

configure the DI3 (Data Input 3 / SLEEP) line for

I/O line passing (use with CD = 1 or 2 and CO)

or controlling connection status (use with MD = 1

or 2).

DT (Destination Address) Command

<Networking> DT Command is used to set the

networking address of an XStream Modem.

XStream Modems use three filtration layers –

Vendor Identification Number (ATID), Channels

(ATHP) and Destination Addresses (ATDT). DT

Command assigns an address to a modem that

enables it to communicate only with other

modems having the same addresses. All modems

that share the same Destination Address can

communicate freely with each other. Modems in

the same network with a different Destination Address (than that of the transmitter) will listen to

all transmissions to stay synchronized, but will not send any of the data out their serial ports.

E0 (Echo Off) Command

<Command Mode Options> E0 Command turns

off character echo in AT Command Mode. By

default, echo is off.

E1 (Echo On) Command

<Command Mode Options> E1 Command turns

on the echo in AT Command Mode. Each typed

character will be echoed back to the terminal

when ATE1 is active. E0 is the default.

ER (Receive Error Count) Command

<Diagnostics> Set/Read the receive-error. The

error-count records the number of packets

partially received then aborted on a reception

error. This value returns to 0 after a reset and is

not non-volatile (Value does not persist in the

modem’s memory after a power-up sequence).

Once the “Receive Error Count” reaches its

maximum value (up to 0xFFFF), it remains at its

maximum count value until the maximum count

value is explicitly changed or the modem is reset.

AT Command: ATDR

Binary Command: 0x2D (45 decimal)

Parameter Range: 0 – 4

Parameter

Configuration

Disabled

DI3 I/O passing enabled

Connect on low

Disconnect on high

Connect and Disconnect

Default Parameter Value: 0

Number of bytes returned: 1

Related Commands: CD (DO3 Configuration),

CO (DO3 Timeout), MD (RF Mode)

Minimum Firmware Version Required: 4.30

AT Command: ATDT

Binary Command: 0x00

Parameter Range: 0 – 0xFFFF

Default Parameter Value: 0

Number of bytes returned: 2

Related Commands: HP (Hopping Channel), ID

(Modem VID), MK (Address Mask)

AT Command: ATE0

Binary Command: 0x0A (10 decimal)

AT Command: ATE1

Binary Command: 0x0B (11 decimal)

AT Command: ATER

Binary Command: 0x0F (15 decimal)

Parameter Range: 0 – 0xFFFF

Default Parameter Value: 0

Number of bytes returned: 2

Related Commands: GD (Receive Good Count)