Product manual

XStream-PKG-R™ RS-232/485 RF Modem – Product Manual v5.x00
CD (DO3 Configuration) Command
<Command Mode Options> CD Command is
used to redefine the behavior of the DO3 (Data
Output 3)/RX LED line.
CE (Connection Inactivity Timeout) Command
<Networking and Security> Set/Read the
duration of inactivity that will cause a break in a
connection between modems. The base modem
will disconnect when no payload has been
transferred for the time specified by the CE
parameter.
CF (Connection Failure Count) Command
<Diagnostics> Set/Read the number of times the
base modem expired retries attempting to send a
Connection Grant Packet.
Set the parameter value to zero to clear the
register.
CL (Last Connection Address) Command
<Diagnostics/Networking and Security> Read
the address of the remote modem that last
connected to the base modem. A remote modem
will return its DT (Destination Address)
parameter.
CM (Connection Message) Command
<Networking and Security> Select whether base
sends connect messages to the host when a
connection is established. When enabled, a
“CONNECTXXXX” string is sent to the host of the
base modem. “XXXX” is the MY (Source Address)
of the connected remote modem.
AT Command: ATCD
Binary Command: 0x28 (40 decimal)
Parameter Range: 0 – 2
Parameter
Configuration
0
RX LED
1
Default high
2
Default low
3
(reserved)
4
Assert only when packet
addressed to modem sent
Default Parameter Value: 0
Number of bytes returned: 1
Minimum Firmware Version Required: 4.2B
AT Command: ATCE
Binary Command: 0x34 (52 decimal)
Parameter Range: 0 – 0xFFFF
(x 10 milliseconds)
Default Parameter Value: 0x64 (1d second)
Number of bytes returned: 2
Related Commands: CB ( Connection Duration
Timeout), DC (Disconnect), MD (RF Mode)
Minimum Firmware Version Required: 4.30
AT Command: ATCF
Binary Command: 0x35 (53 decimal)
Parameter Range: 0 – 0xFFFF
Default Parameter Value: 0
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
AT Command: ATCL
Binary Command: 0x39 (57 decimal)
Parameter Range: 0 – 0xFFFF (read-only)
Number of bytes returned: 2
Minimum Firmware Version Required: 4.30
AT Command: ATCM
Binary Command: 0x38 (56 decimal)
Parameter Range: 0 – 1
Parameter
Configuration
0
enable
1
disable
Default Parameter Value: 0
Number of bytes returned: 1
Minimum Firmware Version Required: 4.30
© 2014 Digi International Inc. 27