User`s manual

©2013DigiInternational,Inc.. 6
XPress™EthernetBridgeGettingStartedGuide
Part 2: Specifications
ThisdocumentcontainsinformationontheXEBfunctionalityonly.IfyouhavepurchasedanXEBwith
XPress™CryptoModule,pleaserefertotheXPress™CryptoModuleUser’ sGuideformoreinformation.
Characteristic Specification/Description
Supported Protocols
TCP/IP, Rockwell (RSLinx EtherNet/IP, CSP), Modbus/
TCP
RF Transmission Rate 1.536 Mbps
Ethernet Throughput 935 Kbps
Output Power +21 dBm (125 mW), (4 W EIRP with 15 dBi antenna)
Receiver Sensitivity
-97 dBm at 10
-4
bit error rate
Range
Up to 1000 ft (300 m) indoor with 2.1 dBi dipole
antennas
Up to 2 miles (3.2 km) outdoor line of sight with 2.1 dBi
dipole antennas
Up to 15 miles (24 km) outdoor line of sight with high-
gain antennas
Radio Channels /
Bandwidth
12 channels (6 in international version) with 2.0833 MHz
spacing and 1.75 MHz occupied bandwidth
Manual Frequency Select
Channel selected with dipswitch or via web browser
interface
Connector Types
RF RPTNC female / Ethernet RJ-45 / Power Jack P5-2.1
mm center positive
Status LEDs
Power, Ethernet Link, RF RX, RF TX, 4/Channel and
6/Link Quality
Error Correction Technique Sub-block error detection and retransmission
Adjacent Band Rejection SAW receiver filter attenuates cellular interference
Regulator Type Switching regulator
Browser Management
Tools
QoS Statistics, Network Settings, Spectrum Analyzer and
Firmware Upgrading
Power Consumption Transmit: 1.7 W Receive: 0.8 W
Vo l t a g e Power over Ethernet 9-48 VDC pins 4/5 positive and
7/8 ground