User`s manual

PAGE 6
Technical support [phone] www.digi.com
XPress Ethernet Bridge User’s Manual
7. The admin page has sections similar to the login page showing radio statistics and device
information plus it adds several new sections. The Device Settings section allows setting the
network information and choosing an RF frequency channel. The default is to allow the radio
to choose its own frequency based on minimizing interference. If you set a xed channel,
make sure the AP and all SUs use the same one. References to DIPs on this and the next web
page refer to switches inside the radio that are used in the legacy method of conguration and
may be ignored when using the browser method.
5. Make note of the chosen IP address and password, then click “Go to Device Web Page.”
This will cause your default web browser to launch with the device IP address in the browser
address bar. Or you may launch the browser on your own and enter the web page address
manually: http://[the IP address you just set].
6. The browser page that loads rst shows the current device information and QoS statistics
and provides a login at the upper right. Log in using the password you just specied (or “pass-
word” if you kept the default). If the login succeeds, you will see an admin page similar to
this:
The information on the left is the current status of
the radio, while the boxes on the right allow you
to change it. It is important that the IP address of
the XPress is in the same subnet as your computer.
For example, if the subnet mask is 255.255.255.0
(a class C network), the rst three number groups
of the IP address must match. Choose your desired
parameters and click “Apply.”