International Network Card User Manual

Advanced Operation

Contact Digi Support if your application requires:

• Over 16 SUs per AP for roaming/mobility

applications

• Multiple APs that use the same network key for

roaming/mobility

• Low packet loss rates when using broadcast or

multicast Ethernet packets.

Note: If possible, fixed IP addresses are recommended on your network. This is because broadcast

and multicast packets (e.g., DHCP, UDP) are sent once and may experience losses at extended range.

Unicast packets (e.g., HTTP, TCP) are sent using advanced error correction and retransmission

techniques to ensure delivery.

Technical Specifications

Characteristic Specification/Description

RF transmission rate 1.536 Mbps

Aggregate Throughput 935 Kbps

Output power +21dBm

Receive sensitivity -97dBm at lOe-4 BER

Ethernet Interface RJ45 10BaseT, Auto MDI/MDIX

Radio channels 12 Non-overlapping

Automatic frequency select Yes - radio channel automatically selected

and adaptively optimized

Manual frequency select Yes

Status LEDs Power, RF TX, RF RX, Ethernet Link,

6/Channel and 6/Link Quality

Error correction technique Sub-block error detection and retransmission

Adjacent-band rejection SAW receiver filter attenuates cellular and

pager interference.

Regulator type XEB09-BCS uses Linear Regulator and XEB09-

BIS uses Switching Regulator

Power consumption Transmit: XEB09-BCS 2W XEB09-BIS 1.5W

Receive:XEB09-BCS 1.2W XEB09-BIS 1.0W

Voltage XEB09-BCS: 5-7 VDC

XEB09-BIS: 9-48 VDC Power over Ethernet

Temperature range -40˚C to 70˚C (-40˚F to 158˚F)

Current draw XEB09-BCS:

350 mA

XEB09-BIS:

150mA at 9VDC

110mA at 12VDC

32mA at 48VDC

Radio Size XEB09-BCS: 5.5 in (14.0 cm) x 3.4 in (8.5

cm) x 1.2 in (3.0 cm)

XEB09-BIS: 7.9 in (20.0 cm) x 3.2 in (8.0

cm) x 2.1 in (5.5 cm)

Regulatory Approvals FCC ID (U.S. - Part 15.247) R4N-AW900M, IC

ID (Canada) 5303A-AW900M