User`s guide

XBee Wall Router
53
Associate/
Power LED:
Indicates power and the Wall Router’s ZigBee network association status:
LED status Network association
On, solid green Not associated
On, blinking green Successfully joined
Reset/
Ident button:
Performs a reset and multiple functions for commissioning the Wall Router
in a ZigBee network.
Use a small non-conducive tool with a blunt end to press gently and hold
down button. Consecutive button presses must occur within 800 ms of
each other to perform the desired action.
Button
press
Network
association
Action
Single Associated • If router is asleep, wakes unit for 30 seconds.
• Sends a Node Identification broadcast transmission.
All devices that receive this transmission will blink their Associate LED rapidly
for 1 second.
All API devices that receive this transmission will send a Node Identification
frame out their UART (universal asynchronous receiver/transmitter) (API ID
0x95).
Unassociated • If router is asleep, wakes unit for 30 seconds.
• Blinks a numeric error code on the Assc LED, indicating the cause of join
failure.
1 blink: Scan found no PANs.
2 blinks: Scan found no valid PANs based on current SC (Scan Channel) and
ID (PAN ID) settings.
3 blinks: Valid Coordinator or Routers found, but they are not allowing joining
(NJ expired).
7 blinks: Node Joining attempt failed.
10 blinks: Coordinator Start attempt failed.
Two Associated Temporarily enables joining on the Wall Router and the entire ZigBee network for
1 minute (if the XBee module’s NJ command setting is less than 255). If joining is
permanently enabled on a module (NJ = 255), joining remains permanently
enabled, and this button press has no effect.
Four Associated/
Unassociated
Router leaves PAN, if associated, and issues a factory reset to restore default
parameters. Default PAN ID is 0x234.
Hold for
five
seconds
Associated/
Unassociated
Performs a hardware reset.