User`s guide

XStick ZNet 2.5
48
Overview
The XStick ZNet 2.5 is a USB peripheral module adapter that provides
short-range wireless connectivity to a ZigBee Mesh network.
Power requirements
The XStick ZNet 2.5 is a USB bus-powered device.
Connection and startup
Plug the XStick ZNet 2.5 into the USB connector of a PC, or use a USB
extension cable. The extension cable must be no more than 3 meters long.
Download and install device driver
The XStick ZNet 2.5 requires a device driver, FT232R. To download this
device driver, go to this web page and select the download appropriate for
your operating system:
http://www.ftdichip.com/Drivers/VCP.htm
Unsupported XBee AT commands
The XStick ZNet 2.5 does not support these XBee AT commands:
LEDs and buttons
Chapter 9
XStick ZNet 2.5
•D0 •D1 •D2 •D3 •D4 •D6 • IS
•IC •P0 •P1 •P2 •RP •%V •V
Associate/
Power LED:
This LED is located inside the case of the device. It indicates whether the
device is powered and its ZigBee network association status:
LED status Network association
Off Not associated.
On, blinking green Powered and associated.