User`s guide

XBee Sensor Adapter
41
Overview
The XBee Sensor Adapter provides short range wireless connectivity to
Digi Watchport
®
Sensors, with available solutions for both mesh (including
ZigBee) and point-to-multipoint networks. Unlike an embedded wireless
module, which requires design integration and development time, these
off-the-shelf adapters provides instant wireless connectivity to existing
Watchport Sensors. All XBee adapters can be used with Digi's
ConnectPort X gateways for data aggregation and IP connectivity
Available sensor products
The XBee Sensor Adapter can be used with a variety of Watchport
sensors. For a description and list of supported sensors, go to Digi’s
Drop-in Networking page at www.digi.com/din, navigate to Products, and
click on Sensors.
Power options
Depending on adapter model, there are several powering options.
Alkaline battery model
This product can be powered by a 9-30VDC external power supply (see
"Power requirements" on page 68) or by batteries. Use 3x1.5V “N” alkaline
battery cells. To install batteries, insert a screwdriver in the slots in the side
of the adapter case and twist to snap off the cover. Insert the batteries
following the polarity diagram on the board.
Lithium battery model
This model can be powered by a 3-6VDC external power supply or by 2/3
AA 3.6V lithium batteries and a 1/2 AA boost capacitor. Replacement
batteries available for purchase; contact Digi at 952-912-3444 or
877-912-3444.
Connection and power-on
1. Connect the sensor to the SENSOR port of the adapter.
2. Connect the power supply to the adapter or insert batteries.
Chapter 7
XBee Sensor Adapter