Datasheet

Features/Specifications
• Network protocols: UDP/TCP, DHCP
• LEDs: Ethernet status, power, cellular
link/activity, signal strength (4 bars),
ZigBee link/activity, Wi-Fi link/activity
• Security - SSL tunnels, SSHv2,
FIPS 197 (serial port)
• Real-time clock
Router/Security Features
•NAT
• Port forwarding
• Access control lists (IP filtering)
VPN Features
• IPsec with IKE/ISAKMP
• Multiple tunnel support
• DES, 3DES and up to 256-bit
AES Encryption
• VPN pass-through, GRE forwarding
Management
• HTTP/HTTPS web interface
• Password access control
• IP service port control
• Optional secure enterprise
management via
Digi Connectware Manager
FEATURES
• Safety: UL 60950, CSA 22.2 No. 60950,
EN60950
• Emissions/Immunity: CE, FCC Part 15
(Class A), AS/NZS CISPR 22, EN55024,
EN55022, Class A
• Mobile Certifications - CDMA/EV-DO:
CDG, TIA/EIA-690, TIA/EIA-98-E
• Mobile Certifications - GSM/UMTS:
PTCRB, NAPRD.03, GCF-CC, R&TTE,
EN 301 511
REGULATORY
APPROVALS
• Width: 4.11 in (10.40 cm)
• Height: 1.30 in (3.30 cm)
• Length: 7.7 in (19.5 cm)
• Weight: 1.50 lb (0.68 kg)
with one PCIe module
DIMENSIONS
• Operating temperature:
-20° C to 60° C (-4° F to 140° F)
• Relative humidity: 5% to 95%
(non-condensing)
• Ethernet isolation: 1500VAC min
per IEEE802.3/ANSI X3.263
• Serial port protection (ESD):
+15 kV Air Gap and +8 kV
contact discharge per IEC 1000-4-2
ENVIRONMENTAL
Serial
• 1 RS-232 DB-9M serial port
• Throughput up to 230 Kbps
• Full signal support for TXD, RXD,
RTS, CTS, DTR, DSR and DCD
• Hardware and software flow
control
USB
• 2 powered USB Type A
connectors (Host)
Ethernet
• 1 RJ-45 port
• Standard: IEEE 802.3
• Physical Layer: 10/100Base-T
• Data rate: 10/100 Mbps
(auto-sensing)
• Mode: full or half duplex
(auto-sensing)
Sensor
• 1 RJ-45 port
Cellular
• EV-DO/1xRTT or HSDPA/EDGE/GPRS
PCI Express Module
ZigBee/802.15.4
• XBee-PRO (Freescale and Ember
supported)
Optional (via PCIe Module)
• Global Positioning System (GPS)
• Wi-Fi (802.11b/g)
- Ad-hoc & AP Client Modes only;
Access Point Mode not supported
• Local storage (up to 1 GB)
INTERFACES
• Power input: 9-30VDC
• 12VDC power supply for 0° C to
60° C (32° F to 140° F) with locking
barrel connector included;
extended temperature power
supply available separately
• Power consumption:
Idle: 3.1 W, Max: 9 W
• Surge protection (with included
power supply): 4 kV burst (EFT)
per-4-4, 2 kV surge per EN61000-4
POWER
REQUIREMENTS
Antenna Type
• ZigBee/802.15.4 - 4" dipole
with 2' cable, tabletop mountable
(same type antenna is used for
Wi-Fi configured gateways)
• Cellular - 7" dipole
Connector Type (on Gateway)
• 50 ohm SMA
• Female for ZigBee & Wi-Fi
• Male for cellular
ANTENNAS
Model North America International
Series 1
ConnectPort X8, Ethernet X8-A11-E-A X8-A11-E-W
ConnectPort X8, Ethernet and
Wi-Fi 802.11b/g X8-A11-W-A X8-A11-W-W
ConnectPort X8, Ethernet and Cellular (AT&T 3G HSDPA) X8-A11-C02-A N/A
ConnectPort X8, Ethernet and Cellular (Sprint 3G EV-DO-A) X8-A11-C10-A N/A
ConnectPort X8, Ethernet and Cellular (Verizon 3G EV-DO-A) X8-A11-C11-A N/A
ConnectPort X8, Ethernet and Cellular (EU 3G HSDPA) N/A X8-A11-C09-W
ConnectPort X8, Ethernet and Cellular (Generic 3G HSDPA) N/A X8-A11-C01-W
Series 2
ConnectPort X8, Ethernet X8-B11-E-A X8-B11-E-W
ConnectP
ort X8, Ethernet and Wi-Fi 802.11b/g X8-B11-W-A X8-B11-W-W
ConnectPort X8, Ethernet and Cellular (AT&T 3G HSDPA) X8-B11-C02-A N/A
ConnectPort X8, Ethernet and Cellular (Sprint 3G EV-DO-A) X8-B11-C10-A N/A
ConnectPort X8, Ethernet and Cellular (Verizon 3G EV-DO-A) X8-B11-C11-A N/A
ConnectPort X8, Ethernet and Cellular (EU 3G HSDPA) N/A X8-B11-C09-W
ConnectPort X8, Ethernet and Cellular (Generic 3G HSDPA) N/A X8-B11-C01-W
Series 1 and Series 2 gateways are based on different and incompatible ZigBee/802.15.4 platforms. Series 1
gateways must be used with Series 1 XBee modules and adapters and Series 2 gateways with Series 2 XBee
modules and adapters.
MODEL......................PART NUMBERS