Specifications

Wavespeed/S Configuration Guide (90000407 Rev. C) – Page 8
Specifications
Power Input: 5V
3-Position Switch
A 3-position switch (ON/OFF/CONFIG) determines the device’s current mode. ON is the
normal operational mode for the device. CONFIG puts the device in configuration mode.
Female DB-9 Connector
Configurable Port Settings
Device Type
DTE: Data Terminal Equipment
DCE: Data Communication Equipment
Baud Rate: 300, 1200, 2400, 4800, 7200, 9600, 19200, 38400, 57600, 115200 (flow control
required)
Data Bits: 7, 8
Stop Bits: 1, 2
Parity: None, Odd, Even
Flow Control
None
Software (user-specified XON/XOFF)
Hardware (RTS/CTS)
Green Status LED
The green LED on the side of your Wavespeed/S shows the current condition of the unit. The conditions
are listed in the table below.
Off The application is not running. Make sure the
device has power and the 3-way switch is not in the
OFF position.
Continuously On On power up, the LED remains on while the device
initializes.
One rapid blink every
5 seconds
Device is in normal operation mode and a wireless
connection has been successfully made.
Two rapid blinks every
5 seconds
Device has initialized successfully but is not
connected to another device.
More than two rapid
blinks every 5 seconds
Internal hardware error condition.
Continuous rapid
blinking
Firmware error condition.