Specifications

Wavespeed/S Configuration Guide (90000407 Rev. C) – Page 7
9. When all settings are specified, click Set Port
Configuration to send the settings to the local device.
10. After viewing the confirmation message, click Next.
Configure Local Device
11. You may give the device a unique name.
12. Authentication: If authentication is enabled, the
Wavespeed/S unit only connects to units that provide a
matching PIN code as part of the authentication
process. The PIN code is case sensitive and may be any
combination of ASCII characters up to a maximum of
16.
13. By selecting Encryption, the Wavespeed/S and the unit
that it is connected to will encrypt wireless
communications according to the Bluetooth standard
encryption scheme.
14. Clicking Advanced allows you to set the following:
a. Reset Link Keys (unchecked by default): The
authentication process creates a link key that
remembers an authenticated remote device (one
that has given the proper PIN code). By checking
Reset Link Keys, the Wavespeed/S deletes all
stored link keys.
b. Link Timeout (default 20 seconds) is the number
of seconds that the Wavespeed/S waits after losing
the signal from a remote device before it drops a
connection. If the remote device comes back into
range within the timeout interval, the connection is
still active on the Wavespeed/S and
communication may continue. However, once the
connection is dropped, the units must reestablish
the communications link.
15. When all selections are specified, click Set Port
Configuration to send the settings to the remote
device.
16. After viewing the confirmation message, click Next.
Flash Update
17. Click Save to store the new settings.
18. Turn off both Wavespeed/S units by sliding the three
position switch to the middle position for two seconds.
19. Place the Wavespeed/S unit in the On mode by sliding
the three-position switch back to the left (toward the
power connector).